ZCGP150LII - GE Monogram™ 15" Built-In Compactor for Custom Panels
Dimensions and Installation Information (in inches)
This compactor is designed as a built-in appliance
only. It may be located in any convenient space
under a countertop.
Front View (not to scale)
DO NOT OPERATE FREE-STANDING because the compactor
will tip over when the drawer is pulled out.
Additional Specifications: A 115 Volt, 60 Hz. power supply
is required. An individual properly grounded branch circuit
protected by a 15- or 20-amp circuit breaker or time delay
fuse is recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall. Electrical
outlet location is critical for proper cord storage when
compactor is installed.
34" - 35"
15-1/8"
min.
24"
min.
If the compactor is to be located in or near a corner of base
cabinets, allow 6” minimum clearance from the corner for
bag removal on the right side.
Locate the outlet 18" min.
from the floor, 3" min.
from either side.
3/4
Thick
Custom
Panel
29-5/16
33-3/4" min.
to
35" max.
23"
e
14-7/8"
14-7/8
Clearances: Allow 6" clearance
to a vertical wall on the right side
for bag removal. Allow 23" at the
front for a full drawer opening.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Listed by
Underwriters
Laboratories
R
Specification Revised 10/05
160008
|