INSTALL INSTRUCTIONS KK-ST-FLIP
FLIP DOWN REAR STEP OPTION
(For Rear Permanent Mount Step order with KK-x-ST-RP)
TOOLS REQUIRED:
Ratcheting wrench
Standard socket set
Open-end wrench set
Power drill
Drill bit set
HARDWARE:
QTY DESCRIPTION
PART #
10
4
32
10
4
½” x 1 ½” Hex head bolt
½” x 3 ½” Hex head bolt
½” Flat washer
½” Lock washer
½” Nylock nut
½” Hex nut
GSM33050
GSM33055
GSM31012
GSM31030
GSM30020
GSM30011
GSM30046
10
2
¼” Stainless nylock nut
SUB ASSEMBLY:
1. Confirm receipt of all parts.
2. Flip down portion of step will come assembled.
3. Slide Support Channels into the Step.
4. Bolt together using (4) ½” x 4” Hex Head Bolts, ½” Nylock Nuts, ½” Flat Washers.
Note: Be sure that flat side of Support Channels face towards outside of vehicle
INSTALLATION:
1. MOUNT FRAME BRACKETS:
• Determine Driver and Passenger side Frame Brackets using view on final page.
• Line brackets up with holes in frame rail of vehicle.
• Bolt brackets to frame using (4) ½” x 1 ½” Hex Head Bolts, ½” Hex Head Nuts,
½” Flat Washers, and ½” Lock Washers
• Do not tighten hardware at this time.
Note: FORD VANS Only: You must use a spacer between the Frame Rail and the Frame
Bracket on the forward mounting holes. Use (2) ½” Supplied flat washers
2. MOUNT STEP AND RAIL ASSEMBLY:
• Step can be mounted at various heights.
• With height determined, loosely bolt Assembly to Frame Brackets using (6)
½” x 1 ½” Hex Head Bolts, ½” Hex Head Nuts, ½” Flat Washers, and ½” Lock
Washers
3. FINAL SQUARING:
• With step square at desired height, tighten all hardware.
KK-ST-FLIP-INST-6-07
|
Carrier MINIMUM LOAD CONTROL ACCESSORY 30XA080 500 User Manual
Carrier SINGLE PACKAGED ELECTRIC COOLING UNITS 50GS User Manual
Danby DPAC9010 User Manual
Energizer Battery Charger CHUSB User Manual
Energizer EV2PC User Manual
Epson XP 600 User Manual
Fisher Price T4144 User Manual
Friedrich 2003 User Manual
GE AZ85E12EAC User Manual
Honda Automobiles Backup Sensors 08V67 SJC 1000 81 User Manual